I have bought some Rover Vitesse wheels to fit my P6 and am looking for suitable wheel nuts.
Presuming that the Vitesse still had 7/16" UNF thread then standard vitesse wheel nuts should do.
Ideally I want 20 in stainless steel but I know that will be impossible, so I need either 20 to get me going or just one as a pattern so I can make them myself out of stainless steel.
Failing either of those has anyone got one they can measure the external dimensions from, hex width, length of hex section, shank diameter and shank length.
Incidentally, if anyone is looking for special wheelnuts I found this site extremely useful when sourcing nuts for some Minilite replicas to fit
http://www.graystonengineering.com/wheelnutspage.htm
Grayston don't supply direct to the public but were more than helpful with advice and I then ordered what they specified through Larkspeed.
Many thanks in adavance!!
Probably best to get me on robin.haslam555@virgin.net
Presuming that the Vitesse still had 7/16" UNF thread then standard vitesse wheel nuts should do.
Ideally I want 20 in stainless steel but I know that will be impossible, so I need either 20 to get me going or just one as a pattern so I can make them myself out of stainless steel.
Failing either of those has anyone got one they can measure the external dimensions from, hex width, length of hex section, shank diameter and shank length.
Incidentally, if anyone is looking for special wheelnuts I found this site extremely useful when sourcing nuts for some Minilite replicas to fit
http://www.graystonengineering.com/wheelnutspage.htm
Grayston don't supply direct to the public but were more than helpful with advice and I then ordered what they specified through Larkspeed.
Many thanks in adavance!!
Probably best to get me on robin.haslam555@virgin.net