Recent content by Nickthelomas

Back agen rovers up and running agen but sadly it must sell, on trade me atm. So my kids lost my keys, i marked all my wiring and took barrel to get a new key cut. In the mean time my partner took to the inside with some spray and wipe making all my carefull marking disappear. so i can get it...

And is that in GBP?

Do I purchase these from u? Or a website?

Thanks Harvey, is there a website with listings and prices for overhaul kits for 35 and or 65 box?

Not sure if I'll get the zf any more unless i find one closer could I be told I were to purchase this http://www.trademe.co.nz/motors/car-par ... 454806.htm, with my broken bw35 could it go in to my rover, I'd imagine I'd only needa change bell housing, T C, linkages and tail end casing? But...

http://www.trademe.co.nz/motors/car-par ... 623227.htm Thanks a lot for the advise, if u follow this link and check out the q and a at the bottom could u tell me if this would be ideal, I'm not sure about the bell housing of this just yet, I will ask thou. If its not right if a lt97 bell...

Could u tell me the modifications needed to fit rich? Is it just output shaft flange and speedo or is it modding driveshafts floor plans and mounting brackets?

So the one I'm looking at is out of a jag, are the output shaft flanges interchangeable with 35 or 65 box or am I better of waiting for something else to come up?

There is a zf 4hp22 on trademe in new Zealand, what's is this ldv Harvey mentions if you don't mind me asking?

Thanks heaps for the help Harvey, I'll be over hauling the 35 with the 65 gears, appreciate your input been fantastic. One last thing, sorry in advance. If the band is too to tight would It make a noise like I discibed, or what would the dragging cause the gearbox to do, until I get it in to...

Just outa curiosity, do u use a range rover gbox and remove the transfer box? Or is there different kinds of lt77's

And to save some coin could I just fit the 65 internals to the 35 box as only the planetary gears are smashed in the 35 so at least could I use the 65 planetary gears?

Also I did not adjust rear band (drivers side) and the front band took 3 or 4 turns before it started to go tight. What does the rear band control and is it worth a shot adjusting it befor removing gbox?

Righto, what if the band is to tight. The closest thing I could get to a torque wrence was making my 8mm spanner one ft long and hanging a 4.5lb weight off it, I left .5 of a lb off to accommodate the weight of my spanner contraption. I have cleaned filter and sump reassembled and oiled up, upon...

Great Thankyou so much, one last thing could u clarify N/S and O/S