I'm looking for a little advice. My v8 has always been a bit tappety when warm but recently it is sounding very loud and my oil pressure is down to 5psi when idle. A colleague at work suggested that the top of the engine is starved of oil hence the noise. I think the oil pump may be the problem...
I'm looking for advice on replacing the hockey sticks and drain channels above. I have replacement parts and I would guess that the hockey stick was originally attached with spot welds. Can I use plug welds from above to attach them or should I go down a different route?
Thanks,
Paul
Hello all. I am looking for the aluminium metal bracket that is used to attach the rear wing seal between the back door and the wing. I have the drivers side so I just need the passenger one. I have new rubbers on order so it is just the metal I need.
Thanks,
Paul
Why is it that you always run out of gas right at the end of the welding job. I clearly need to do something. Sacrificing poultry perhaps?
I'm just venting my frustration :)
I'm having trouble uploading pictures to the forum in the members projects section. Getting the error below.
"Sorry, the board attachment quota has been reached."
Could it be that the size settings need increased by a forum admin?
Thanks,
Paul
I'm looking for the interior trim that covers the inside of the c post on the drivers side. Mine has sustained some welding damage in the past.
Thanks,
Paul
Hello all,
I'm looking for the front brake pad wear wiring connection for my 3500S. What I need is the metal bracket that bolts onto the back of the caliper along with the plug and a few inches of cable. The plug and wiring without the bracket would also be good.
The drivers side on my car has...
Bit of a problem. The bolts that hold the front calliper to the upright are both seized and I need to swap the discs so they have to come off. They need re-conditioned in any case.
The question is....how do I get them off? I've tried brute force and blood and I'm getting nowhere. 40 years of...
Hello all. As some of you may have read in previous posts ARJ has a new owner (ME :D ) and I thought I would share my amateur mechanical efforts. I've never tried working on a car before but I'm keen to give it a try.
The car is still running on the distributor borrowed from a very nice P5B so...
I'm swapping the coil in my 3500S for a new unit as part of a new electronic ignition distributor. There is a small part with a green wire that was attached to the coil bracket but the wire was not connected to anything. Can anyone help me with identifying what it is. Pictures below.
I also...
Hello.
Thought I would post up a picture of ARJ163L in its new home and say hello to everyone. Just picked it up today and can't stop thinking about all the jobs I want to do.
No.1 on the list is to fix the distributor and return the borrowed unit.
Paul
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.